1. Winding connection method
The network cable is also the transmission of electrical signals, so the network cable can be manually connected like a wire. The most primitive, the simplest, the most brutal way to connect; the eight cores of the network cable are stripped, each core screwed solid, two of the same line sequence of the network cable wound together, and through the insulation tape for winding; of course, someone will certainly ask, what about such effects?
Although the network cable so wrapped together, but after all, the network cable is the transmission of data, it is not the same as the wire transmission current, so the signal loss and interference will be greater, so the winding method is also the stability of the worst kind of an extension method. Only suitable for emergency or temporary detection, not suitable for long-term use.
2. Wiring sub-method
In the use of network cables, over time, it is inevitable that breakage or broken by rats, etc., if broken, communications personnel is how to do it?
You can use the junction, the 8-core network cable connected, it is a broadband maintenance using a more connection method, long for the network cable is broken by the mouse bite, the local extension of the scene;
Easy to implement, just need to insert the ends of the network cable adapter and fixed, 100 megabit network can be connected only 1, 2, 3, 6 four-core copper wire, gigabit, then you need 8 network cables are connected. So you need to prepare at least 8 adapter (junction), the use of the method is also relatively simple, but some notes.
The need to extend the ends of the network cable peeled off to reveal 3-5 centimeters, you need to pay attention to the color difference between the network cable, the connection needs to be connected one by one, do not connect.
3. Connector method
You can also use the network cable connector connection, not long enough to make a good crystal head at one end of the cable, plug directly into the connector. The other end, and then connect the crystal head to another network cable. The use of connectors, the solution to the network cable is not long enough method is simple, the cost is not high, it can be said that the connector method is the simplest, but also more practical method.
4. Soldering method
Welding method, in fact, the first winding method is relatively similar, the network cable is not long enough in theory, you can also use the traditional method of welding. The 8-core wire in the network cable, respectively, welding, the color must match. Compared to the network cable connector this method, welding technology requires high, and to have professional welding tools. This method is not recommended, one because the average person will not bring welding tools is; two because the operation is troublesome, the welding process requirements are relatively high; three because the effect is general.
