Fiber preparation
1. Remove the outer sheath of the optical cable (if any, remove the shielding and armor), and then remove the wrapping layers until the loose tube is exposed. For the specific method, please follow the standard method recommended by the optical cable manufacturer. The preparation length is 3 meters.
2. Clean the loose tube and the reinforced core sheath with detergent, remove the excess filling tube, and polish the outer sheath of the optical cable 150mm long with the provided sandpaper.
Optical cable installation
1. Select the sealing ring with the smallest inner diameter according to the outer diameter of the optical cable, and put the two sealing rings on the optical cable.
2. Put the optical cable into the corresponding hole.
3. Connect the shield and ground.
4. Wrap the self-adhesive sealing tape between the two sealing rings so that the sealing tape is wound to be flush with the outer diameter of the sealing ring to form a sealed end of the optical cable.
5. Press the sealed end of the optical cable into the cable entry hole.
6. Use a hose clamp to pass through the fiber optic cable reinforcing rib fixing seat and the cable core support, and fix the fiber optic cable on the base of the connector box. Tighten the hose clamp screw until the hose clamp is tightened.
7. Tie a nylon cable tie on the optical cable and cut off the excess length.
8. Please use plugs to seal the other unused optical cable holes. Sealing tape is also wrapped around the plug, and the requirements are the same as 5.2.4.
9. Wrap the reinforcing member on the countersunk screw of the splice tray support and press it tightly.
