1, the front side of a clean fiber optic wipe paper wipe clean ceramic insert.
2, the fiber optic wipe paper placed horizontally on the workbench, under the pad more than a few.
3, the smooth side of the fiber optic wipe paper facing up.
4, hand holding the connector, so that the PC connector ceramic insert perpendicular to the fiber optic wipe paper, APC connector, you need to wipe at an angle of 8 degrees.
5, along the grain of the fiber optic wipe paper
6, according to a single direction gently wipe 2-3 times, can not wipe back and forth, not in the same location of the fiber optic wipe paper repeatedly wipe
7, and then to the detector to check until Yu net so far.
8, pay attention to the force to light when wiping. Wipe marks >= 1cm.
9, after cleaning, the temporary non-use of optical fibers need to jumper the dust cap to wear, jumper wire winding, no winding, intertwining and other phenomena
