1.We will prepare the cutter and fast connector, open the previous connector and see if the pre-buried fiber is broken inside. If the fiber is not broken inside, we just need to take out the fiber carefully, and then put the newly made fiber optic head into it and close the bite cap. In most cases, the fiber optic cable is broken inside the connector, this is the connector can not be reused, you need to replace it with a new one to use.
2. Observe the structure of the connector: a blue shell, black fiber optic cold splice body above a fiber optic cable gland, the end of the connector screw cap. After recognizing the construction of the fiber optic connector, let's make the fiber optic connector. The optical fiber will be set aside from the outer skin, pay attention to the fiber optic cable can not be bent, otherwise it can not be used. After the skin, we will screw the cap to the fiber optic fiber above, set up after the first do not care about him. Strip the fiber optic sheath to a section of bare wire larger than 22 mm, this is because in a moment we are going to use 22 mm fiber optic head. After stripping, here you must use a fiber optic cutter. Put the fiber optic head on the cutter to cut off the part that is more than 22mm. After the above steps a standard fiber optic connector is ready.
3. Insert the fiber optic head through the hole at the back of the connector, the depth of insertion to the extent that the fiber is slightly bent. Do not press too hard when inserting to avoid breakage. Next, put the cover of the fast connector up to fix the fiber optic connector, and then screw the screw cap of the fiber optic fast connector up to fix it.
Fiber optic fast connector installation steps are not complicated, but the installer's technical requirements are high. Fiber optic requirements for cleanliness is relatively high, if it is defaced at the time of installation there will be poor signal or interruption of the fault. If you make a fiber optic fast connector that doesn't work, it's probably because the fiber is tainted or broken due to lack of care during installation.
